2.4Hz Wireless Digital Video Camera lens: There are two kinds of CS

What is a 2.4Hz Wireless Digital Video Camera ? 




2.4Hz Wireless Digital Video Camera lens: There are two kinds of CS and C type, both threads are one inch 32 tooth, one inch in diameter, the difference from the CCD camera is different from the target surface, C from the reference mount type from the surface to the focal point of 17.562 mm, than the length of the CS-type CCD target surface from a dedicated multi-ring pick, CS style from the focal distance of 12.5 indoor cctv camera mm. Do not underestimate this one up lap, without it, the lens and the camera can not focus properly, the image becomes blurred. So before installing the camera, first look at the camera and the lens is not the same kind of interface mode, if not, then you need to increase or decrease depending on the circumstances circle. Some cameras do not pick laps, but after using image adjustment ring (such as Panasonic products), when adjusted with a screwdriver to loosen the adjusting screw on the ring, turn the adjustment ring, this time will be relatively CCD target surface mounting base back (before) movement, also play wireless video monitoring project a role in connection circle. Further the like (e.g., SONY, JVC) as the adjusting ring in a manner that the fixing screws on the side of the camera in general, loosen the adjusting gear at the top, can not make the image clear and subtraction ring.AGC ON / OFF (AGC): Within a camera signal from the CCD is amplified to the level of the video amplifier can be used, i.e. the amount of amplification gain, equivalent to a higher sensitivity, whereas the light in the light the amplifier will be overloaded environment, the video signal distortion. When the switch is in ON, in low light WiFi PTZ Camera conditions fully open lens aperture automatically increase the gain to get a clear image. Switch is OFF, the low luminance and low noise for natural images.



2.4Hz Wireless Digital Video Camera into consideration during operation, the camera is exposed directly to air, the air in the presence of more or less the total number of the dust, the dust is likely to be scattered on the surface of the camera, the camera if the time does not clean the surface of the case , then the camera imaging screen will appear blurred. Therefore, in order to avoid the camera away from the invasion of dust, we must make sure that the camera work is no dusty environment, and after the completion of the video interaction task, we must remember to use the cover of the camera to protect, to minimize dust and direct invasion opportunities. If found camera imaging screen rather ambiguous, may wish to check whether its surface dust cover, if found to have dust, then be sure to use a soft cotton cloth to cover the camera surface dust wipes, followed by glasses cloth or professional lens paper wipe then fine, but during wiping, try to start the camera center begins. Also need to remind you that the camera lens focal lengthwant to implement video surveillance need to download the software SupervisionCam
2.4Hz Wireless Digital Video Camera CmakeList.txt production .......................................... .................................................. ...... 13 Lens: 2.0mm ? third quarter after entering the exit status view camera and forecast A: Check the operating system, BIOS, USB interface to install any mistake



2.4Hz Wireless Digital Video Camera 7, restore the demolition of the rear part camera universal driver PC Camera 301P is a very simple camera drivers, almost all auto market for the current camera is generic drivers. Universal camera driver is your best choice ...universal camera driver how to install?